Посмотреть гаражВот на что наткнулся на сайте бмв-водов за бугром ;)))
Переводить влом... копипаст будет как есть %)
first, start with the aforementioned straw. cut a lengthwise slit at the end, 3/4" to 1" in length.
trim some of the straw by cutting another lengthwise slit.
remove the trimmed portion.
insert the trimmed straw into the connector by compressing the straw end to size - if you trimmed the straw enough, you should be able to squeeze it down to the size of the pin w/o much if any of the straw's wall overlapping where the slit is. you must wedge the straw BETWEEN the outside of the metal pin and the plastic plug body. be sure the straw does not go inside the hollow metal pin - that won't do anything.
press wire and straw firmly inwards to engage the pin's fingers.
after straw will not insert further, extract the pin by pulling on wire. a firm tug may be needed, but do not use excessive force.
if the wire does not come out, the straw may have not seated properly - start over with a clean end and try trimming more off the straw and/or using a thinner straw. however do not trim too much off the straw - there should still be enough in its circumference to cover the 4 fingers of the pin without overlapping excessively.
that's it. in the illustrations i show the connector that comes with the iPod harness, but the same procedure will work with the larger radio harness.
пруф
Сообщение отредактировал e404: 21 September 2012 - 13:25 PM
